Hydroseeding in Dallas, TX

Hydroseeding in Dallas looks simple on a map, because most of the city is flat and sits between 450 and 550 feet above sea level. The exception is the western edge of the Austin Chalk, the limestone rise people call the White Rock Escarpment. It climbs about 230 feet and runs north to south through Dallas County, and south of the Trinity River it is plain to see in Oak Cliff. Those two settings call for different seed mixes, different mulch rates and different erosion control.

Flat clay lots

On the flat parts of the city, the trouble is water that sits rather than water that runs. Heavy clay takes rain slowly, so we fine grade each yard to a steady fall away from the slab before any slurry goes down. A new lawn installation on a level lot mostly comes down to getting that grade right and spreading enough topsoil for roots to get started.

Oak Cliff and other slopes

Where the escarpment shows up, a standard hydromulch can wash before the grass roots. On steeper banks we step up to a bonded fiber matrix or pin erosion control blankets on the face, then spray seed over or through them. Toe-of-slope silt fence keeps soil off the street until the cover fills in.

Near the Trinity

The river runs between earthen levees about 50 feet tall, and land near it is floodplain. Work there tends to be commercial and public ground where sediment control and inlet protection go in before grading starts, and the seeding plan has to hold up if water comes over it.

Picking the month

Dallas normals put the wettest months in May and October, with July and August the driest and hottest. We like to seed warm-season grass from late spring into early summer and use fall for repairs and overseeding, so new turf gets rain on its side instead of fighting the August heat.

We give written estimates for hydroseeding services anywhere in the city, from a single backyard to a builder's whole phase. Get a free estimate or call (469) 210-5759.